Automation for cleaning surfaces before painting / coating
The CO2 used for cleaning surfaces is recovered almost exclusively from industrial exhaust gases. Environmental pollution is caused exclusively by energy consumption for recovery / liquefaction and by transport. CO2 cleaning is therefore an absolutely environmentally friendly and residue-free process. IceMaster is the modern process for industrial cleaning with dry ice / dry snow.
Our application examples show the advantages of using the IceMaster system.
The adjacent plant is used for the pre-treatment of plastic parts before coating with the help of the automated IceMaster-system.
The JetMaster from mycon GmbH is environmentally friendly and saves resources. The water consumption is extremely low with 0.20 – 1.00l clear water per minute. JetMaster works without any additional chemicals. Thus, the amount of waste water is extremely reduced compared to other aqueous cleaning methods and is only polluted by the mostly harmless soiling of the surfaces in this area.
Cleaning heat exchangers with the JetMaster system developed by mycon
Finned heat exchanger cleaning by automated JetMaster AS cleaning system – from outside.
Finned heat exchanger cleaning by automated JetMaster AS cleaning system – from inside.
Cleaning of cooling towers
The pipes in the cooling tower were temporarily supplied with lime-containing water. As a result, a hard limestone armour had developed around the pipes.
The JetMaster combination system successfully cleaned the outer pipe surfaces.
The zinc coating – which had been destroyed by chemical cleaning – is not attacked by JetMaster.