The CO2 used for cleaning surfaces is recovered almost exclusively from industrial exhaust gases. Environmental pollution is caused exclusively by energy consumption for recovery / liquefaction and by transport. CO2 cleaning is therefore an absolutely environmentally friendly and residue-free process. IceMaster is the modern process for industrial cleaning with dry ice / dry snow.
Our application examples show the advantages of using the IceMaster system.
The adjacent plant is used for the pre-treatment of plastic parts before coating with the help of the automated IceMaster-system.
The mycon GmbH does not only offer automated solutions for the IceMaster system. The devices of the JetMaster and SpeedMaster series can be automated indefinetly and are also available for rent. We will be pleased to provide you with an offer tailored to your requirements for renting or purchasing an automated version of our devices.
Please note our contact form.
The video above shows an automated solution of the IceMaster. In this case it is used to pretreat plastic parts before painting.
The JetMaster from mycon GmbH is environmentally friendly and saves resources. The water consumption is extremely low with 0.20 – 1.00l clear water per minute of use. JetMaster works without the addition of chemicals. Thus, the amount of waste water is extremely reduced compared to other aqueous cleaning methods and is only polluted by the mostly harmless soiling of the surfaces in this area.
Finned heat exchanger cleaning by automated JetMaster AS cleaning system – from outside.
Finned heat exchanger cleaning by automated JetMaster AS cleaning system – from inside.
Spiral ribbed heat exchanger cleaning by automated JetMaster AS cleaning system – from outside.
Spiral ribbed heat exchanger cleaning by automated JetMaster AS cleaning system – from inside.
Examples of the automated JetMaster system – cleaning of heavily soiled finned tubes