Make cleaning more efficient / reduce physical strain on employees

mycon GmbH presents new cleaning and coating technologies for the railway sector

Cleaning oil cooler

Oil coolers are an important part of the locomotive’s hydraulic system. In diesel-driven locomotives, the cooling water is also cooled with the unit. The oil cooler is often very dirty, and conventional high-pressure water cleaning in the installed state often has its trouble here. Cleaning is also exhausting and exhausting.

JetMaster has also cleaned oil coolers successfully, quickly and gently in the installed condition. The cleaning time is usually only 10-15 minutes. But this cleaning work has also been exhausting so far.

mycon has now improved these processes. The jet nozzle of the JetMaster is now positively guided and moved over the exchanger surface by means of a special lance. The physical load with the cleaning, which is accomplished in addition still in bent attitude, is thereby strongly reduced.

Cleaning Heat exchanger Air conditioning systems / other coolers

JetMaster operates at high blasting speed; the abrasive used in the unit is specially pre-treated water (normal drinking water quality). The high speed of the nozzle jet leads to a higher noise level, at least for the operator. Hearing protection is therefore mandatory. However, the noise level is already greatly reduced at a distance of 10m. mycon has now developed nozzle attachments especially for the railway sector which reduce the noise level even further. In addition, the amount of spray water is reduced, which is already low in terms of the cleaning principle when using the JetMaster due to the low amount of water used of less than 1 l per minute.

Safety / exposure of weld seams for the purpose of visual inspection

mycon uses the PowerMaster device with a special blasting nozzle for this area. This blasting nozzle requires only a greatly reduced amount of compressed air and abrasive. This reduces the development of damp dust, which can be further reduced by an additional nozzle attachment.

Cleaning / paint stripping of bogies, wheel sets and other surfaces

With the SpeedMaster device system, mycon offers the option of either cleaning or stripping the paint. The device system can be used both manually and fully automatically.

Cleaning of exhaust particle filters / other filters

FilterMaster gently, quickly and cost-effectively cleans even dirty exhaust particle filters from locomotives. The cleaning is carried out pressureless with a small amount of non-flammable, non-toxic (even drinkable) liquid. The filter is then dried at a temperature far below that otherwise required for the filters to burn out. Before and after the cleaning of the exhaust particle filters a complete documentation is made, which is transmitted to the customer.

Coatings

mycon also offers coatings for the high temperature range. The coatings can also be hydrophobic. Almost all surfaces can be coated.

First check, then rent or buy for a longer period!

mycon offers all devices at a favourable price also for a test month in your house. This test rental will be credited in full if the device is subsequently rented/purchased for a long period of time. If required, we will be happy to support you during commissioning.